Difference between revisions of "CNC Bender v11-20091201"

From ATTWiki

Jump to: navigation, search

Revision as of 03:44, 2 December 2009

Type of Upgrade: FLEXIBILITY

The changes in this version are changes to CNC Bender for better flexibility.

NEW- Logic Allows Push Buttons to Toggle States

CNC Bender now allows logic to make a physical momentary push-button into a toggle switch. For example, push the button to switch a state on, then push it again to switch the state off.

For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle ON and OFF using a push button.
It is also possible to illuminate the button according to the current End Cycle state.

ENHANCED- Edge Triggerized [IF] Parameters Optimization

Edge triggers now reset properly when repeating the same inputs in multiple [IF] and [IFNOT] commands in the list of commands.

If an edge triggerized input is true in an IF line, then the edge trigger is CLEARED - UNLESS the entire set of logic in that parameter line returns FALSE as a whole. In that case the edge trigger is set back to TRUE (it is SET).

This allows for same edge triggered input to be used in several different [IF] and [IFNOT] blocks in the same processlist.

NEW- Better Warning for Missing Processlists

Messages now display for missing High Speed Constant Run Processlist

UPDATE- Improved Grids in Dynamic Option Lists

New grid source with improvements for better performance.

REPAIR- Counter in RunPage is Updated to Zero When Run is Complete

The part count updated normally except when the Runlist Run is complete. This is corrected.

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v11-20091201&oldid=12631"