Difference between revisions of "AICON"
From ATTWiki
| Line 10: | Line 10: | ||
<br> | <br> | ||
| + | ==Connecting AICON to an Eaton Leonard Bender== | ||
| + | This diagram shows how our software and hardware is used to connect an AICON TubeInspect measuring center to VELOG, EL-2000, and Premier bender controls. (Click on the image for a close-up.) | ||
| + | <br> | ||
[[image:aicon_to_eatonleonard_diagram.jpg|450px]] | [[image:aicon_to_eatonleonard_diagram.jpg|450px]] | ||
Revision as of 14:56, 7 December 2009
The AICON TubeInspect system is a vision-based tube measuring system used to setup, correct, and verify tube part shapes.
The Advanced Tubular Technologies Benderlink for Eaton Leonard [1] can use AICON data to correct Eaton Leonard benders using the legacy EL Current Loop protocol.
Link the AICON TubeInspect Web Site
Connecting AICON to an Eaton Leonard Bender
This diagram shows how our software and hardware is used to connect an AICON TubeInspect measuring center to VELOG, EL-2000, and Premier bender controls. (Click on the image for a close-up.)
