Difference between revisions of "Modicon Momentum"
From ATTWiki
(→Other Pages) |
(→Ethernet Communication Adapter) |
||
| Line 38: | Line 38: | ||
[[image:tsxmomentum_ethernet_communications_adapter1.jpg|300px]] | [[image:tsxmomentum_ethernet_communications_adapter1.jpg|300px]] | ||
| + | [[image:tsxmomentum_ethernet_communications_adapter2.jpg|300px]] | ||
Revision as of 12:20, 23 December 2009
This the form of the modules that are installed to SMT CNC Bender. For example, the I/O module is shown above.
See this data sheet (16 pages) for an overview of these modules.
View the Modicon Momentum I/O Base User Guide (662 pages).
They mount to DIN rails in electrical panels.
|
This is the form for the I2T servo modules |
|
|
In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. |
|
Ethernet Communication Adapter
This is an Ethernet Communications Adapter on top of a 32 point input base.
Other Pages
- Back to CNC Bender page
- Back to CNC Bender General Information page
- Back to CNC Bender Technical Notes page
