Difference between revisions of "CNC Bender v12-20100316"

From ATTWiki
Jump to: navigation, search
(→‎25px NEW - Feed Speed Percentage Adjustment for Feed Bend Mode)
(→‎25px NEW - Feed Speed Percentage Adjustment for Feed Bend Mode)
Line 33: Line 33:
  
 
<table>
 
<table>
−
<tr><td width=75>Value</td><td>The value is entered as a percentage.</td></tr>
+
<tr><td width=75>Value Type</td><td>The value is entered as a floating point percentage.</td></tr>
 
<tr><td>+ or -</td><td>The value can be positive or negative floating point number.</td></tr>
 
<tr><td>+ or -</td><td>The value can be positive or negative floating point number.</td></tr>
 
<tr><td>Negative Values</td><td>Negative values slow the calculated speed of the Feed axis.</td></tr>
 
<tr><td>Negative Values</td><td>Negative values slow the calculated speed of the Feed axis.</td></tr>

Revision as of 12:58, 16 March 2010

Cncv12procontrol withteachmode.jpg

Type of Upgrade: Feature Upgrade

New Bend option added

V12mainmenu.jpg

Contents


Check.jpg NEW - Feed Speed Percentage Adjustment for Feed Bend Mode

This new bend option allows you to fine-tune the calculated feed speed during Feed Bending.

Value TypeThe value is entered as a floating point percentage.
+ or -The value can be positive or negative floating point number.
Negative ValuesNegative values slow the calculated speed of the Feed axis.
Example +A value of +100 would double the speed of the Feed axis during draw bending.
Example -A value of -100 would set the speed at 0 for the Feed axis during draw bending.

FeedSpeedPercentageAdjustmentOption.jpg

For example "-10" means negative 10 percent.

Speed calculated at 100% (see vel0)
Processlist feedspeedadjustbefore.jpg

Same speed calculated at 90%(see vel0)
Processlist feedspeedadjustafter.jpg



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20100316&oldid=13704"