Difference between revisions of "CNC Bender v12-20100611"
| Line 21: | Line 21: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging. | + | CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.<br><br> |
| + | |||
| + | [[image:euchnerpendant.jpg|150px]] | ||
</td> | </td> | ||
<td> | <td> | ||
Revision as of 14:06, 14 June 2010
|
|
|
Contents |
NEW - CNC Bender Jog with Joystick or Pendant
|
CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.
|
|
REPAIRED - Benderlink Database Transfer Setup Clear
|
The CNC Bender database was corrupted when Benderlink users pressed the "Apply and Close" button without first having made a correction. The result was a CNC Bender setup that would cause major issues in CNC Bender. |
|
REPAIRED - Single Radius Carriage Shifting
|
Single radius carriage shifting is now re-enabled in this version. |
|
REPAIRED - Direct Axes Jog Buttons Stick Down
|
If the Immediate Message box displays while an operator is pressing a JOG+ or JOG- button in direct axes jog mode, then CNC Bender would never allow the jog button to come up. This has been resolved. |
|
REPAIRED - Automatic Feed Adjustment During Part Load
| The automatic feed adjustment feature works by advising operators that incoming part data was from another bender with a different bed length. We discovered that two of the Tool page options were not being changed properly. This is corrected. | |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
