Revision as of 14:09, 14 June 2010

@@ Line 38: / Line 38: @@
 </table>
-===[[image:Check.jpg|25px]] REPAIRED - Benderlink Database Transfer Setup Clear===
+===[[image:Check.jpg|25px]] NEW- Direct Axis Jog from INPUT Options===
 <table>
 <tr valign=top>
 <td width=300>
-The CNC Bender database was corrupted when Benderlink users pressed the "Apply and Close" button without first having made a correction.  The result was a CNC Bender setup that would cause major issues in CNC Bender.<br><br>
+The low level general options list contains three new options:  ENABLE, JOG+ Input Name, JOG- Input Name.  If this feature is enabled, then the input names are used to lookup the input points in the CIO dictionary.<br><br>
-This issue has been corrected by automatically updating the Adjusted database when Benderlink shows on the screen.  There is no possibility that the the setup database can now be cleared improperly.
 </td>
 <td>

Difference between revisions of "CNC Bender v12-20100611"

The low level general options list contains three new options: ENABLE, JOG+ Input Name, JOG- Input Name. If this feature is enabled, then the input names are used to lookup the input points in the CIO dictionary.

Single radius carriage shifting is now re-enabled in this version.

If the Immediate Message box displays while an operator is pressing a JOG+ or JOG- button in direct axes jog mode, then CNC Bender would never allow the jog button to come up. This has been resolved.

The automatic feed adjustment feature works by advising operators that incoming part data was from another bender with a different bed length. We discovered that two of the Tool page options were not being changed properly. This is corrected.