Difference between revisions of "CNC Bender v12-20100611"
| Line 24: | Line 24: | ||
In the MANUAL page, the Direct Axis jog button must be active for external devices to control the jog. | In the MANUAL page, the Direct Axis jog button must be active for external devices to control the jog. | ||
<br><br> | <br><br> | ||
| − | In the CUSTOM COMMAND EDITOR page, the "TEACH MODE" must be active and an axis row selected for external devices to control the jog. | + | In the CUSTOM COMMAND EDITOR page, the "TEACH MODE" must be active and an axis row selected for external devices to control the jog. Also, in the editor, the joystick and or teach-pendant controls both SERVO and DIRECTIONAL-VALVE actuators. This means that the joystick can also be used to close and open the chuck, clamps, and dies. |
</td> | </td> | ||
<td> | <td> | ||
Revision as of 14:59, 14 June 2010
|
|
NEW - CNC Bender Direct-Axis Jog with Joystick or Pendant
|
CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.
|
|
NEW- Setup Options for Direct Axis Jog from INPUTS
|
The low level general options list contains three new options:
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
