Difference between revisions of "CNC Bender v12-20100707"
From ATTWiki
| (5 intermediate revisions by one user not shown) | |||
| Line 16: | Line 16: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | The sustain time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module.<br><br> | + | The sustain time is used to control how long the output modules stay on around the CNC Bender system even if they are not being serviced. |
| − | + | <br><br> | |
| + | The time is setup in the Processor tab of the low level menu, and was previously applied only to the first output module.<br><br> | ||
| + | |||
| + | As of this version, it is applied to all the output modules throughout the entire system.<br><br> | ||
| + | |||
| + | </td> | ||
<td> | <td> | ||
| − | [[image: | + | [[image:modicon_on_din.jpg|250px]]<br> |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 29: | Line 34: | ||
</td> | </td> | ||
</tr> | </tr> | ||
| − | |||
| − | |||
| − | |||
</table> | </table> | ||
Latest revision as of 00:58, 8 July 2010
|
|
ENHANCED - All Output Modules Now Use Extended Sustain Time
|
The sustain time is used to control how long the output modules stay on around the CNC Bender system even if they are not being serviced.
As of this version, it is applied to all the output modules throughout the entire system. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
