Difference between revisions of "DOCS2Addison Benderlink"
From ATTWiki
(→SETUP Screen) |
(→SETUP Screen) |
||
| Line 22: | Line 22: | ||
<tr> | <tr> | ||
| − | <td width= | + | <td width=300>This is where all setup occurs in Benderlink. Up to 100 benders can be programmed and '''remembered'' in this Benderlink. <br><br> |
</td> | </td> | ||
<td>[[image:docs2addison_mainscreen_setup.jpg|400px]]</td> | <td>[[image:docs2addison_mainscreen_setup.jpg|400px]]</td> | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
</tr> | </tr> | ||
Revision as of 03:49, 30 July 2010
| DOCS2Addison Benderlink is software is designed to allow the AddisonMckee to communicate with the DOCS-based measuring center. |
 |
|
 |
SETUP Screen
| This is where all setup occurs in Benderlink. Up to 100 benders can be programmed and 'remembered in this Benderlink. |
 |
RUN Screen
This is the screen where Benderlinking occurs. Choose the bender number in the Setup screen, then switch to RUN.
This is the RUN screen:
Other Pages
- Back to Benderlink
