Difference between revisions of "CNC Bender v12-20101021"
From ATTWiki
| Line 26: | Line 26: | ||
</table> | </table> | ||
| − | ===[[image:Check.jpg|25px]] | + | ===[[image:Check.jpg|25px]] FIXED - Early Mandrel Extra On Last Bend === |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=200> | <td width=200> | ||
| − | + | For benders with motion controlled PDA, the early mandrel extract did not work on the last bend.<br><br> | |
| − | This | + | This has been repaired so that the feature works. |
</td> | </td> | ||
<td> | <td> | ||
| − | [[image: | + | [[image:ball_mandrel.jpg]] |
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 20:04, 22 October 2010
|
|
Contents |
NEW - Added Input Timer in PreEnable
|
Schneider Lexium drives require a pulse to switch from READY to RUN mode. This feature was added to allow for pulsing Lexium drives a specific amount of time before the axes were enabled. |
|
FIXED - Early Mandrel Extra On Last Bend
|
For benders with motion controlled PDA, the early mandrel extract did not work on the last bend. |
|
NEW - FEED TORQUE ZEROED DURING MANDREL RETRACT
|
The FEED TORQUE is now set to ZERO% during mandrel retractions. This prevents possible destruction of the FEED gearbox, rack, pinion, chain, if the tube breaks during bending and the mandrel pulls the tube and carriage back. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
