CNC Bender has a new splash screen

A new timer is added to CNC Processor to regulate the response to joystick-type jog motion. This allows for steady jog motion no matter what other process the processor performing.

The default jog speeds for each axis are now set inside the main.axislist configuration file.

The new property name is "Default Jog Speed="

The new Default Jog Speed value is shown here in a main.axislist file:

The speeds are reset to default:

1. When Processor runs the Init Axis processlist
2. When Processor senses a change between operation modes (manual, step, auto)
3. When exiting the Custom Command Editor

Each axis has its own Default Jog Speed property.
Value handling:

• If the default jog speed property and value are not present or the property name is misspelled in the main.axislist file for any axis, then the value defaults to "20" inside CNC Processor.
• If a default jog speed is negative, it is reset to the positive value.
• If a default jog speed exceeds the maximum speed for an axis, then it is reset to the maximum speed.