Difference between revisions of "CNC Bender v12-20101223"
From ATTWiki
| (2 intermediate revisions by one user not shown) | |||
| Line 14: | Line 14: | ||
| − | ===[[image:Check.jpg|25px]] REDESIGNED - | + | ===[[image:Check.jpg|25px]] REDESIGNED - [[Run Page]] === |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=200> | <td width=200> | ||
| − | The | + | The [[Run Page]] is redesigned so that the next step is a very large message. |
<br><br> | <br><br> | ||
The [[Step List]] is removed from this page as it is too much information for some users.<br> | The [[Step List]] is removed from this page as it is too much information for some users.<br> | ||
| Line 25: | Line 25: | ||
<td> | <td> | ||
[[image:runpage_large_nextstep.jpg|450px]] | [[image:runpage_large_nextstep.jpg|450px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] NEW - New Diagnostic Tab Menu === | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=200> | ||
| + | A new diagnostic tab menu contains the [[Step List]] that was previously on the [[Run Page]]. | ||
| + | <br><br> | ||
| + | This list allows operators to view the steps the bender is performing in realtime. | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:runpage_diagnostic_steplist.jpg|450px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Latest revision as of 20:26, 25 December 2010
|
|
Contents |
REDESIGNED - Run Page
|
The Run Page is redesigned so that the next step is a very large message.
|
|
NEW - New Diagnostic Tab Menu
|
A new diagnostic tab menu contains the Step List that was previously on the Run Page.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
