Revision as of 18:36, 14 February 2011

v12-20110212

OEMs now have option list control that is protected by encryption. Any list option can be switched off by the OEM during machine setup.

Push Bend Allow and PDA-RVG Allow no longer switch on automatically in the general dynamic options list if a license for either option is found in the hardware key. Only the setup technician can enable or disable these values in the Low Level menu of CNC Bender ProControl.

If the CNC Bender Options Visibility configuration file is not present, then CNC Bender will not load.
The splash screen will show this message:

The CNCBenderDOD.cfg filename is changes to DynamicOptionVisibility.cfg in order to better reflect the purpose of the file.

@@ Line 41: / Line 41: @@
 * If the CNC Bender Options Visibility configuration file is not present, then CNC Bender will not load.<br><br>
 * The splash screen will show this message:<br><br>
+</td>
+<td>
+[[image:cncbender_splash_nooptionvisibilityfile.jpg|400px]]
+</td>
+</tr>
+</table>
+<br><br>
+===[[image:Check.jpg|25px]] Other Changes  ===
+<table cellpadding=10>
+<tr valign=top>
+<td width=300>
+* The CNCBenderDOD.cfg filename is changes to DynamicOptionVisibility.cfg in order to better reflect the purpose of the file.
+<br><br>
+* If this file does not exist, then CNC Bender will not run.
 </td>