Difference between revisions of "CNC Bender v12-20110215"
From ATTWiki
| (3 intermediate revisions by one user not shown) | |||
| Line 15: | Line 15: | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] REPAIR - CNC Processor Die Avoidance | + | ===[[image:Check.jpg|25px]] REPAIR - CNC Processor Die Avoidance Checks === |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
| − | <td width= | + | <td width=400> |
| − | This repairs logic for checking for | + | This repairs logic for checking for checking inputs for three collision conditions in the dies:<br><br> |
| − | + | # OK for Feed To Exceed EOT Safe Radius Change<br>Using the Carriage Cross Slide Input<br><br> | |
| − | + | # OK for Feed To Exceed EOT Pressure Die<br>Using Pressure Die Home Input<br><br> | |
| − | + | # OK for Horizontal Head Shift with Clamp Open<br>Using Clamp Die Home Input<br> | |
<br> | <br> | ||
</td> | </td> | ||
<td> | <td> | ||
| + | [[image:proxswitch.jpg]] | ||
</td> | </td> | ||
Latest revision as of 16:02, 15 February 2011
v12-20110215
|
|
REPAIR - CNC Processor Die Avoidance Checks
|
This repairs logic for checking for checking inputs for three collision conditions in the dies:
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
