Difference between revisions of "CNC Bender v12-20110308"
From ATTWiki
| Line 29: | Line 29: | ||
</table> | </table> | ||
| − | ===[[image:Check.jpg|25px]] NEW - "Lost Home" Tolerance === | + | ===[[image:Check.jpg|25px]] NEW - "Lost Home" Tolerance Increased === |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| + | CNC Processor previously had zero tolerance for a HOME state that switches to OFF then back ON again quickly.<br><br> | ||
CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.<br> | CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.<br> | ||
</td> | </td> | ||
Revision as of 16:08, 8 March 2011
v12-20110308
|
|
NEW - STEP Mode only
|
A new STEP Mode only option is available in low level. When enabled, CNC Bender will only run in STEP mode. |
NEW - "Lost Home" Tolerance Increased
|
CNC Processor previously had zero tolerance for a HOME state that switches to OFF then back ON again quickly. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
