Revision 1.61

Back to VTube-LASER

Floating end letters can be switched on to help identify the ends A and B of the tube.

Control the state of the labels in the View Control pane on the right side of the screen.

If either End A or End B are set to a value of ZERO, then they will be automatically calculated based on the straight measurement adjacent to the end of the tube.

The Part Setup on the right is from a measurement of B end tube straight where a 1.130" expansion was measured. End B was set to zero, and VTube automatically filled in the expanded end diameter.

If VTube discovers a default radius value of ZERO, then it will automatically reset the default radius to 1.5 times the nominal diameter before converting to the measured menu.

• The Diameter Measure control was redesigned.
  
  

• The Apply to Nominal Diameter button in the Diameter Measure control now properly transfers diameter data to the Part Setup menu.
  
  

• The Apply to Nominal Radius button in the Radius Measure control now properly transfers radius data to the Part Setup menu.
  
  

• The End B diameter is no longer overwritten by the End A diameter.
  
  

• The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. Fixed in VTube-LASER v1.62