Difference between revisions of "CNC Bender v12-20110308"
From ATTWiki
| (One intermediate revision by one user not shown) | |||
| Line 15: | Line 15: | ||
__NOTOC__ | __NOTOC__ | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | ===[[image:Check.jpg|25px]] NEW - "Lost Home" Tolerance === | + | ===[[image:Check.jpg|25px]] NEW - "Lost Home" Tolerance Increased === |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| + | CNC Processor previously had zero tolerance for a HOME state that switches to OFF then back ON again quickly.<br><br> | ||
CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.<br> | CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.<br> | ||
</td> | </td> | ||
Latest revision as of 18:08, 24 March 2011
v12-20110308
|
|
NEW - "Lost Home" Tolerance Increased
|
CNC Processor previously had zero tolerance for a HOME state that switches to OFF then back ON again quickly. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
