Difference between revisions of "Setup VTube-LASER for the Network License Manager"
From ATTWiki
(→STEP 2) |
(→STEP 2) |
||
| Line 25: | Line 25: | ||
== STEP 2 == | == STEP 2 == | ||
| − | Install the VTube-STEP software. | + | Install the VTube-STEP software. |
| − | + | Run VTube-STEP. | |
| − | In | + | In System Options, display the General Config tab. |
| − | + | <br> | |
| − | + | [[image:vtube-laser-generalconfig.jpg|300px]] | |
| − | + | <br> | |
| − | + | Use the | |
| + | |||
<br><br> | <br><br> | ||
(Note: Versions earlier than 1.64c use a different set of folders based on the user name.) | (Note: Versions earlier than 1.64c use a different set of folders based on the user name.) | ||
Revision as of 18:27, 12 May 2011
|
Back to VTube-LASERUse these steps to setup VTube-LASER for use with the Network License Manager software.
|
|
STEP 1
Start the NLM software on the server computer. (See Network License Manager for more information.)
STEP 2
Install the VTube-STEP software.
Run VTube-STEP.
In System Options, display the General Config tab.
Use the
(Note: Versions earlier than 1.64c use a different set of folders based on the user name.)
Step 3
Do not run VTube during the following steps:
Load the cfg file into an editor like Notepad or Wordpad. Find the [Hardware Key] section:
[Hardware Key] NLM IP Address=127.0.0.1 Network Timeout=10 Send To NLM Port=17500 Receive From NLM Port=17501 Enable Network=0 License Type=Laser
Step 4
Change the address to the address of your server IP. (This entry is an example)
[Hardware Key] NLM IP Address=192.168.0.100 Network Timeout=10 Send To NLM Port=17500 Receive From NLM Port=17501 Enable Network=0 License Type=Laser
Step 5
Change the Enable Network value to 1.
[Hardware Key] NLM IP Address=192.168.0.100 Network Timeout=10 Send To NLM Port=17500 Receive From NLM Port=17501 Enable Network=1 License Type=Laser
Step 6
Save and close the cfg file then run VTube.
