Difference between revisions of "Setup VTube-LASER for the Network License Manager"

Revision as of 18:28, 12 May 2011

Use these steps to setup VTube-LASER for use with the Network License Manager software.

Start the NLM software on the server computer. (See Network License Manager for more information.)

Press the button in the upper left corner to edit the VTube-LASER configuration file.

(Note: Versions earlier than 1.64c require manual browsing and location of this file.)

Do not run VTube during the following steps:

Load the cfg file into an editor like Notepad or Wordpad. Find the [Hardware Key] section:

[Hardware Key]
NLM IP Address=127.0.0.1
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser

Change the address to the address of your server IP. (This entry is an example)

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser

Change the Enable Network value to 1.

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=1
License Type=Laser

Save and close the cfg file then run VTube.

@@ Line 25: / Line 25: @@
 == STEP 2 ==
-Install the VTube-STEP software.
+*Install the VTube-STEP software.
-Run VTube-STEP.
+*Run VTube-STEP.
-In System Options, display the General Config tab.
+*In System Options, display the General Config tab.
-<br>
+<br><br>
 [[image:vtube-laser-generalconfig.jpg|500px]]
-<br>
+<br><br>
-Use the
+*Press the button in the upper left corner to edit the VTube-LASER configuration file.
 <br><br>
-(Note: Versions earlier than 1.64c use a different set of folders based on the user name.)
+(Note: Versions earlier than 1.64c require manual browsing and location of this file.)
 ==Step 3==