Difference between revisions of "Setup VTube-LASER for the Network License Manager"

From ATTWiki
Jump to: navigation, search
(STEP 2)
(Step 3)
Line 38: Line 38:
  
 
==Step 3==
 
==Step 3==
Do not run VTube during the following steps:<br><br>
+
Find the [Hardware Key] section:
 
+
Load the cfg file into an editor like Notepad or Wordpad.  Find the [Hardware Key] section:
+
  
 
<pre>
 
<pre>
Line 51: Line 49:
 
License Type=Laser
 
License Type=Laser
 
</pre>
 
</pre>
 
  
 
==Step 4==
 
==Step 4==

Revision as of 18:29, 12 May 2011

Vtube-laser logo.jpg

Back to VTube-LASER

Use these steps to setup VTube-LASER for use with the Network License Manager software.


Vtube-laser screen 1 54.jpg




STEP 1

Start the NLM software on the server computer. (See Network License Manager for more information.)



STEP 2

  • Install the VTube-STEP software.
  • Run VTube-STEP.
  • In System Options, display the General Config tab.



Vtube-laser-generalconfig.jpg

  • Press the button in the upper left corner to edit the VTube-LASER configuration file.




(Note: Versions earlier than 1.64c require manual browsing and location of this file.)

Step 3

Find the [Hardware Key] section:

[Hardware Key]
NLM IP Address=127.0.0.1
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser

Step 4

Change the address to the address of your server IP. (This entry is an example)

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser


Step 5

Change the Enable Network value to 1.

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=1
License Type=Laser


Step 6

Save and close the cfg file then run VTube.