Difference between revisions of "Setup VTube-LASER for the Network License Manager"

Revision as of 18:31, 12 May 2011

Use these steps to setup VTube-LASER for use with the Network License Manager software.

Start the NLM software on the server computer. (See Network License Manager for more information.)

Find and load the "vtube local settings.cfg" file.

In Windows Vista and Windows 7, the path will be: c:\ProgramData\VTube

In Windows XP, the path will be: c:\Documents and Settings\All Users\Application Data\Vtube

Find the [Hardware Key] section:

[Hardware Key]
NLM IP Address=127.0.0.1
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser

Change the address to the address of your server IP. (This entry is an example)

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser

Change the Enable Network value to 1.

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=1
License Type=Laser

Save and close the cfg file then run VTube.

@@ Line 25: / Line 25: @@
 == STEP 2 ==
-*Install the VTube-STEP software.
+Find and load the "vtube local settings.cfg" file.
-*Run VTube-STEP.
-*In System Options, display the General Config tab.
-<br><br>
-[[image:vtube-laser-generalconfig.jpg|500px]]
-<br><br>
-*Press the button in the upper left corner to edit the VTube-LASER configuration file.
+In Windows Vista and Windows 7, the path will be:
+c:\ProgramData\VTube
-<br><br>
+In Windows XP, the path will be:
-(Note: Versions earlier than 1.64c require manual browsing and location of this file.)
+c:\Documents and Settings\All Users\Application Data\Vtube
 ==Step 3==