Difference between revisions of "CNC Bender v12-20110525"
From ATTWiki
| Line 24: | Line 24: | ||
* Chuck Close/Open Skip in Post Bend - for special teach mode unloading<br><br> | * Chuck Close/Open Skip in Post Bend - for special teach mode unloading<br><br> | ||
* Processor checks for special internal command '''[BEGIN RUN AGAIN]''' in processlists - which is required even in custom processlists | * Processor checks for special internal command '''[BEGIN RUN AGAIN]''' in processlists - which is required even in custom processlists | ||
| − | * | + | * Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed. |
</td> | </td> | ||
<td> | <td> | ||
| − | |||
</td> | </td> | ||
Revision as of 02:32, 26 May 2011
v12-20110525
|
|
ENHANCED - Changes
|
NEW - SmartInspect Configuration File Added
|
A new configuration file "loggingsetup.cfg" is added to the cnc\config folder.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
