Revision as of 02:36, 26 May 2011

v12-20110525

Chuck Close/Open Skip in Post Bend - for special teach mode unloading
Processor checks for special internal command in processlists - which is required even in custom processlists:

[BEGIN RUN AGAIN]
Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.

CNC Bender can now be loaded from the Start Menu at Windows boot without failing to find the hardware key

@@ Line 25: / Line 25: @@
 * Processor checks for special internal command in processlists - which is required even in custom processlists:<br><br>'''[BEGIN RUN AGAIN]'''<br><br>
 * Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.
+</td>
+<td>
+</td>
+</tr>
+</table>
+<br><br>
+===[[image:Check.jpg|25px]] ENHANCED - Changes to Loading  ===
+<table cellpadding=10>
+<tr valign=top>
+<td width=400>
+* CNC Bender can now be loaded from the Start Menu at Windows boot without failing to find the hardware key<br><br>
 </td>