Revision 1.69

Back to VTube-LASER
Back to VTube-STEP

Measure Setup allows operators to control more FARO server menus, and shows all the current FARO arm and probe data in a grid below the setup buttons.

Many report value fields were added to reports that show the arm and probe calibration and accuracy values. All of these values can be added to any report.



This allows the current state of the arm to be printed with the report - proving that the arm was calibrated during measurement.

VTube now asks if you intend to establish a cut plane immediately after the arm is connected to VTube-LASER.

New tab menus with new options are now placed in separate tab menus in the Master XYZ menu.

• The radius values now correctly copy back to XYZ radius values when performing a reverse calc.

• It is now possible to edit the blue-column bend ANGLE and ANGLE ADJUSMENT data in the Bender Setup menu.

• A new LRA Master to Measured report is added.

• Rotation corrections are always shift to the shortest side of the clock. For example +359 degree is reset to -1.0.

• Now the tangent point/midpoint inspection grid is automatically set with the default tolerance when the grid grows.

• No known issues

VTube-LASER Training Video - How to perform effective end scans.