Latest revision as of 23:51, 20 September 2011

Revision 1.70

VTube-LASER Training Video - How to perform effective end scans.

@@ Line 22: / Line 22: @@
 The inspection mathematics is more accurate and is now better able to work with the short straights in split bends (where VTube combines the bends to make a single large bend).
 <br><br>
-</td>
-<td width=300>
 </td>
 </tr>
@@ Line 33: / Line 30: @@
 <tr valign=top>
 <td width=300>
-The end angles in the inspection report are repaired and show accurate values.<br><br>
+The end angles in the inspection report are repaired and show accurate values.
-<br><br>
 </td>
 <td width=300>
@@ Line 46: / Line 42: @@
 <tr valign=top>
 <td width=300>
-* Transfluid fails to load the diameter and radius values if the values use more than two places of accuracy beyond the decimal.  So now VTube is careful to use only two places of accuracy beyond the decimal for those two values.
+* An "Inspection Points" label is added above the tangent point/midpoint deviation grid.
 </td>
 <td width=300>
 </td>
 </tr>
-<tr valign=top>
-<td width=300>
-* VTube can now correctly import a Transfluid file as MASTER data.
-</td>
-<td width=300>
-</td>
-</tr>
-<tr valign=top>
-<td width=300>
-* The arm as mouse speed is now controlled in the FARO hardware configuration menu - not in VTube-LASER System Options as in previous versions.
-</td>
-<td width=300>
-</td>
-</tr>
 </table>
-<br><br>
 ===[[image:Check.jpg|25px]] Issues with this version fixed in newer versions===