Difference between revisions of "CNC Bender v12-20111101"
From ATTWiki
| Line 26: | Line 26: | ||
<td> | <td> | ||
| + | The default value is "1" which means "true" or "enabled." Use 0 to switch this feature off. | ||
</td> | </td> | ||
| + | |||
</tr> | </tr> | ||
Revision as of 02:17, 1 November 2011
v12-20111101
|
|
NEW - Axis List Setup Parameter: Pulse Enable At Halt
|
"Pulse Enable At Halt=" is a new parameter in the axis list configuration. This allows you to setup CNC Bender to always pulse the enable of an axis during the HALT command. This makes the axis super safe because it always clears all following error. |
The default value is "1" which means "true" or "enabled." Use 0 to switch this feature off. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
