Difference between revisions of "CNC Bender v12-20111229"
From ATTWiki
| Line 13: | Line 13: | ||
</table> | </table> | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===[[image:Check.jpg|25px]] REPAIR - Pressure Die Interference Zone === | + | ===[[image:Check.jpg|25px]] REPAIR - Pressure Die Interference Zone Collision Message === |
<table cellpadding=10> | <table cellpadding=10> | ||
| Line 19: | Line 19: | ||
<td width=400> | <td width=400> | ||
* The pressure die interference logic would stop the bending with a collision fault if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | * The pressure die interference logic would stop the bending with a collision fault if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | ||
| − | + | <br> | |
* This has been resolved with this version. If the PDA is a servo axis, then the potential for collision is ignored. | * This has been resolved with this version. If the PDA is a servo axis, then the potential for collision is ignored. | ||
Revision as of 18:01, 29 December 2011
v12-20111229
|
|
REPAIR - Pressure Die Interference Zone Collision Message
|
|
Other
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
