Difference between revisions of "CNC Bender v12-20111229"
From ATTWiki
| Line 20: | Line 20: | ||
* The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | * The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | ||
<br> | <br> | ||
| − | * Now if the PDA is a servo axis, then the potential for collision is ignored. This will assume that the pressure die is | + | * Now if the PDA is a servo axis, then the potential for collision is ignored if GEARING is switched on in the bend module. This will assume that the pressure die assist is geared to the bend axis. |
</td> | </td> | ||
Revision as of 18:49, 29 December 2011
v12-20111229
|
|
REPAIR - Pressure Die Interference Zone Collision Message
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
