Difference between revisions of "CNC Bender v12-20111229"
From ATTWiki
| Line 18: | Line 18: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | * The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | + | * ISSUE RESOLVED: The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. |
<br> | <br> | ||
| − | * Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm. | + | * RESOLUTION: Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm. |
<br> | <br> | ||
* Note that it is possible for a collision to still occur if the radius value is set incorrectly in the tool page, or the real-time variable gearing for the PDA is set low enough to allow the carriage to catch up to the PDA. | * Note that it is possible for a collision to still occur if the radius value is set incorrectly in the tool page, or the real-time variable gearing for the PDA is set low enough to allow the carriage to catch up to the PDA. | ||
Revision as of 18:53, 29 December 2011
v12-20111229
|
|
REPAIR - Pressure Die Interference Zone Collision Logic Change
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
