Difference between revisions of "VTube-LASER v1.75.1"
| Line 46: | Line 46: | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders=== | ===[[image:Check.jpg|25px]] NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders=== | ||
Revision as of 12:11, 2 February 2012
|
Revision 1.75.1Back to VTube-LASER |
|
ENHANCEMENT: Added Page Numbers to Reports in Print Preview
|
VTube now shows the date, time, and page numbers at the bottom of print preview reports. |
|
FIX: Previous Move During Remeasure
|
There were circumstances where VTube would backup too many steps during a remeasure. This has been repaired. |
NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders
|
VTube now has a second set of tolerances for shorter straights. This allows for looser tolerances on shorter straights without producing an error message.
|
|
Other Changes
|
A new tolerance is added for surface point diameter check. |
|
The current arm firmware is now read and used by VTube to determine how to handle the arm during Scanner Control changes. |
|
|
For high-precision end scans, new end-scan techniques are recommended in the VTube-LASER manual. |
|
|
The VTube SVNET protocol now knows how to handle leftover communications files if they are present. |
|
VTube can now save Supravision data to multiple file extension types: $$$, SV, or S2B |
| VTube-LASER now takes in scanned points faster than before. |
| VTube-LASER installation now allows for installing either MM or INCH default setups. |
| Default setups were fine-tuned in VTube-LASER so that VTube works faster. |
Other Pages
- Back to VTube-LASER
