Difference between revisions of "Lube Machine At Part Count"
From ATTWiki
| Line 15: | Line 15: | ||
Two alternative properties are | Two alternative properties are | ||
| − | < | + | <ul> |
| − | Lube Machine At Bend Count | + | <*>Use Bend Count For Machine Lube |
| − | </ | + | <*>Lube Machine At Bend Count |
| + | </ul> | ||
| + | <ul> | ||
If [[Use Bend Count For Machine Lube]] value is set to 0 then the Lube Machine At Part Count property will be used. Set the [[Use Bend Count For Machine Lube]] property to equal 1 to set CNC Processor to use the "Lube Machine At Bend Count" property.<br> | If [[Use Bend Count For Machine Lube]] value is set to 0 then the Lube Machine At Part Count property will be used. Set the [[Use Bend Count For Machine Lube]] property to equal 1 to set CNC Processor to use the "Lube Machine At Bend Count" property.<br> | ||
<br> | <br> | ||
Revision as of 03:41, 20 July 2006
Contents |
What is It?
This property allows CNC Processor to switch the mandrel lube output to ON after a pre-programmed number of parts have run.
Value
The value is set to milliseconds like this:
Lube Machine At Part Count= 500
In this case, the machine lube will activate after each 500 parts run on the machine.
Alternative Properties
Two alternative properties are
-
<*>Use Bend Count For Machine Lube
<*>Lube Machine At Bend Count
-
If Use Bend Count For Machine Lube value is set to 0 then the Lube Machine At Part Count property will be used. Set the Use Bend Count For Machine Lube property to equal 1 to set CNC Processor to use the "Lube Machine At Bend Count" property.
The Lube Machine At Bend Count property is used to set the bend count for machine lube. --Mcone 23:30, 19 July 2006 (EDT)
