Difference between revisions of "CNC Bender v12-20120723"
From ATTWiki
| Line 21: | Line 21: | ||
<td width=400> | <td width=400> | ||
* The command names for the radius level shifting were often confusing when moving from HEAD shifters to CARRIAGE shifters. For example, on a head shift machine, AllUp meant radius 1. On carriage shift machine, AllUp meant the top radius (2 or 3). | * The command names for the radius level shifting were often confusing when moving from HEAD shifters to CARRIAGE shifters. For example, on a head shift machine, AllUp meant radius 1. On carriage shift machine, AllUp meant the top radius (2 or 3). | ||
| − | + | <br><br> | |
* This ambiguity is cleared up by naming the directional valve positions by RADIUS LEVEL number, rather than "UP" or "DOWN". | * This ambiguity is cleared up by naming the directional valve positions by RADIUS LEVEL number, rather than "UP" or "DOWN". | ||
| − | + | <br><br> | |
* These are thew new command names to use: | * These are thew new command names to use: | ||
** Shift to Radius Level 1 | ** Shift to Radius Level 1 | ||
| Line 40: | Line 40: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] Radius Level Shift Command Names Can Be Changed=== | ===[[image:Check.jpg|25px]] Radius Level Shift Command Names Can Be Changed=== | ||
Revision as of 20:21, 22 July 2012
v12-20120723
|
|
Radius Level Shift Command Names Simplified
|
Radius Level Shift Command Names Can Be Changed
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
