Difference between revisions of "Benderlink for SolidWorks"
From ATTWiki
(→Features) |
|||
| Line 7: | Line 7: | ||
The main features of this software: | The main features of this software: | ||
| − | + | <ol> | |
| − | + | <li> - Read tube data from Solid Works</li> | |
| − | + | <li> - Convert the tube data to bender data</li> | |
| − | + | <li> - Save / Recall the bender data</li> | |
| − | + | <li> - Send new nominal data to benders that support [[SVNET]] protocol.</li> | |
| + | <li> - Make and send correction data to benders that support the [[SVNET]] protocol.</li> | ||
| + | </ol> | ||
The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data. | The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data. | ||
Revision as of 17:46, 28 July 2006
Benderlink for Solid Works software is designed to connect Solid Works workstations to SVNET-based benders. This software also performs data conversion.
http://advancedtubular.com/blink_sw/help_html/clip0003.jpg
Features
The main features of this software:
- - Read tube data from Solid Works
- - Convert the tube data to bender data
- - Save / Recall the bender data
- - Send new nominal data to benders that support SVNET protocol.
- - Make and send correction data to benders that support the SVNET protocol.
The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data.
[1] Read the online help
--Mcone 13:37, 28 July 2006 (EDT)
