Difference between revisions of "VTube-LASER v1.77.3"
From ATTWiki
(→Revision 1.77.3) |
|||
| Line 5: | Line 5: | ||
==Revision 1.77.3== | ==Revision 1.77.3== | ||
* Back to [[VTube-STEP]] | * Back to [[VTube-STEP]] | ||
| − | * Back to [[VTube | + | * Back to [[VTube Software Updates]] |
* Back to [[VTube-LASER]] | * Back to [[VTube-LASER]] | ||
Revision as of 03:45, 8 August 2012
|
Revision 1.77.3
|
|
ENHANCED: View Orientation Control Redesigned
|
|
|
NEW: Diameter Model End Lengths Change Based on New "End Adjustment Length" Values in Part Setup
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: The Cut Length Calculation with Non Zero End Adjustments Is Repaired
| The End Length Adjustments values are no longer doubled in the Cut Length calculation. |
Other Pages
- Back to the VTube page
