Difference between revisions of "CNC Bender v12-20120830"
From ATTWiki
| Line 16: | Line 16: | ||
=== [[image:Check.jpg|25px]] Enhanced: Autoloader Manual Page Redesign === | === [[image:Check.jpg|25px]] Enhanced: Autoloader Manual Page Redesign === | ||
| − | CNC Bender can now make the TUBE ROTATE and SEAM DETECT buttons invisible. See these two screens: | + | CNC Bender can now make the TUBE ROTATE and SEAM DETECT buttons invisible. See these two screens:<br> |
[[image:v12-21020830_autoloader_manual_expanded.jpg|500px]]<br><br> | [[image:v12-21020830_autoloader_manual_expanded.jpg|500px]]<br><br> | ||
| − | This next screen shows the two buttons removed from the screen: | + | This next screen shows the two buttons removed from the screen:<br> |
[[image:v12-21020830_autoloader_manual.jpg|500px]]<br><br> | [[image:v12-21020830_autoloader_manual.jpg|500px]]<br><br> | ||
Revision as of 11:11, 30 August 2012
v12-20120830
|
|
Enhanced: Autoloader Manual Page Redesign
CNC Bender can now make the TUBE ROTATE and SEAM DETECT buttons invisible. See these two screens:
This next screen shows the two buttons removed from the screen:
|
Control the visibility of buttons with new low level options: |
Enhanced HALT in Processor for Servo Motion
|
This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event.
|
Ceased Reporting Error for [BEGIN PROGRAM] Label
|
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. |
Ceased Reporting Error for [BEGIN PROGRAM] Label
|
When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
