Difference between revisions of "How to Setup for Supravision Network Protocol"
From ATTWiki
(→Step 3: Setup the Bender Communication Parameters) |
(→Step 4: Switch to the Measuring Center Name Tab Menu) |
||
| Line 50: | Line 50: | ||
[[image:BlinkEL_MeasuringCenterName.jpg]] | [[image:BlinkEL_MeasuringCenterName.jpg]] | ||
| + | |||
| + | |||
| + | == Step 5: Switch to the Measuring Center Protocol Tab Menu== | ||
| + | |||
| + | Set the name of the measuring center protocol to "Supravision Network". | ||
| + | |||
| + | [[image:BlinkEL_MeasuringCenterProtocol.jpg]] | ||
Revision as of 18:35, 12 September 2012
|
How to setup the SVNET protocol with Benderlink for EL.
|
|
Contents |
Step 1: Enter the Benderlink Network
Open the Tools > Configure Benderlink Network Menu
Step 2: Enter the Benderlink Network
Press the Bender Network tab, then select the bender you want to edit (or add one), then press "Edit".
Step 3: Setup the Bender Communication Parameters
- Each bender number must be unique.
- The name will display in the user interface of Benderlink.
- The COM port is the port number assigned to communicate with this bender.
- Press OK.
Step 4: Switch to the Measuring Center Name Tab Menu
Set the name of the measuring center to one of the types that uses the Supravision Network protocol.
Step 5: Switch to the Measuring Center Protocol Tab Menu
Set the name of the measuring center protocol to "Supravision Network".
