Difference between revisions of "VTube Report Template Location"
From ATTWiki
(→STEP 1 - Click on System Options) |
|||
| Line 25: | Line 25: | ||
====STEP 1 - Click on System Options==== | ====STEP 1 - Click on System Options==== | ||
| + | This will take you into a window with tab | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| Line 34: | Line 35: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| + | |||
====When NOT to Use Damping==== | ====When NOT to Use Damping==== | ||
Damping is not helpful if your tube does not have the characteristic shape shown above. If the tube you are measuring does not have short straights that are basically "jogs" or offsets in longer sections of tubes, then you should turn damping off by unchecking the damping check boxes and/or ignoring all damping report data. | Damping is not helpful if your tube does not have the characteristic shape shown above. If the tube you are measuring does not have short straights that are basically "jogs" or offsets in longer sections of tubes, then you should turn damping off by unchecking the damping check boxes and/or ignoring all damping report data. | ||
Revision as of 16:36, 5 March 2013
|
|
|
Contents |
Follow these steps to locate the Report Templates filesSTEP 1 - Click on System OptionsThis will take you into a window with tab |
|
When NOT to Use DampingDamping is not helpful if your tube does not have the characteristic shape shown above. If the tube you are measuring does not have short straights that are basically "jogs" or offsets in longer sections of tubes, then you should turn damping off by unchecking the damping check boxes and/or ignoring all damping report data.
|
|
Other Pages
- Back to VTube-LASER
