Revision as of 20:15, 12 June 2013

=Revision 1.82.1

VTube can now measure rectangular and square tube shapes with the laser or ball probes.

The laser scanning includes edge detection in order to remove the fillet from the plane calculations. In this image, see how VTube detects edge fillets and removes them automatically from the calculation of the planes.

This change gives more room to the grid of values to display on the screen without scrolling by removing the two buttons from the bottom of the Part Setup menu.

The Connect to Arm feature has been rewritten to make it more robust. It is also now possible to disconnect from the FARO arm at any time using the "Disconnect from Arm" button.
Overbend Calculator is now integrated into VTube. The values are now always updated and transferred back to VTube as they are entered in the Overbend.
Supravision export in STEP mode would send an incorrect wall thickness value. This has been resolved.

@@ Line 28: / Line 28: @@
 VTube can now measure rectangular and square tube shapes with the laser or ball probes.<br><br>
-[[image:vtube-laser-1.82_rectangulartubes_scanneddata.jpg|300px]]<br>
+[[image:vtube-laser-1.82_rectangulartubes_scanneddata.jpg|300px]]<br><br>
+* The laser scanning includes edge detection in order to remove the fillet from the plane calculations.  In this image, see how VTube detects edge fillets and removes them automatically from the calculation of the planes.<br><br>
+[[image:vtube-laser-1.82_rectangular_scanneddata_closeup.jpg|300px]]<br>
 </td>