Difference between revisions of "VTube-LASER Bender Corrections"

• Back to VTube-LASER
• Back to VTube-STEP

Main Screen

VTube-LASER uses the Bender Setup screen to control the values in connected benders.

This screen shows data that is a separate part of VTube memory. The data in this screen is the bender data, both before and after correction, and it is kept unchanged unless changed by the operator.

• The blue columns represent the data at the bender before correction.
  
  
• The orange columns represent the data at the bender after correction.
  
  
• The columns between the blue and orange columns represent the adjustments to the data.
• Finally, the operator can press "3" to clear the current adjustment data from the grid - as it should only be used one time.

Bidirectional Communication Controls

With the right protocol at the bender, VTube-LASER can recall data from the bender, and send both setup and correction data to the bender.

• Operators typically press the "1" button to recall data to be sure the data in the blue columns match the data in the bender.
  
  
• Then they press "2" to send the orange columns to the bender as corrected data.

STEP 3 - Browse into the Report Folder

The Report folder contains html files that are report templates that can be modified.

If you are creating your own template, then we recommend that you load one of the templates into a text editor, make the changes, then save it to a new html file for importing into VTube.

Keep in mind that the filename of the html template will be the template name in the report template list. You can use regular names with spaces like "This Is My Report.html". The template name will then show as "This Is My Report" after it is imported.