Difference between revisions of "CNC Bender v12-20130710"
From ATTWiki
(→25px NEW: :Skip Step Tolerance value in Main.axilist) |
(→25px NEW: :Skip Step Tolerance value in Main.axilist) |
||
| Line 22: | Line 22: | ||
As of this version, the value is only effective for the bend axis. If the bend arm is within this value, then it will consider itself as being home (at zero), and will skip the move to zero to save time.<br><br> | As of this version, the value is only effective for the bend axis. If the bend arm is within this value, then it will consider itself as being home (at zero), and will skip the move to zero to save time.<br><br> | ||
The default value is 0.25.<br><br> | The default value is 0.25.<br><br> | ||
| − | + | ||
| + | <table cellpadding="15"> | ||
| + | <tr><td width=25></td> | ||
| + | <td width=300 bgcolor="#f0f0f0"> | ||
| + | <font size=5>[[image:Gear_warning.jpg]] <b>WARNING!</b><br><br></font> | ||
| + | <font size=3>Setting this value too high may cause the bend arm to never return<br><br> | ||
| + | |||
| + | Please do not attempt to adjust this value without technical assistance from an Advanced Tubular technician. | ||
| + | </font></td></tr></table> | ||
| + | |||
</td> | </td> | ||
Revision as of 16:31, 10 July 2013
v12-20130710
|
|
NEW: :Skip Step Tolerance value in Main.axilist
|
The c:\cnc\config\axis\mail.axislist file contains a new value called "Skip Step Tolerance". This is a floating point value that is only considered positive.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
