Difference between revisions of "Controlling Deadband"
From ATTWiki
(→STEP 3: Insert the COMDEF Name in the PreEnable.cncprocesslist File) |
(→STEP 3: Insert the COMDEF Name in the PreEnable.cncprocesslist File) |
||
| Line 36: | Line 36: | ||
<tr> | <tr> | ||
<td width=500> | <td width=500> | ||
| − | The PreEnable file will run commands before enabling any axis | + | The PreEnable file will run commands before enabling any axis:<br><br> |
<pre> | <pre> | ||
Revision as of 14:57, 9 August 2013
Deadband can be controlled by taking these steps.
Contents |
STEP 1: Create a new CIO
|
Create a new CIO for the servo module in the CIO Editor like this: |
STEP 2: Create a new COMDEF with the new CIO
|
Create a new COMDEF like this: |
STEP 3: Insert the COMDEF Name in the PreEnable.cncprocesslist File
|
The PreEnable file will run commands before enabling any axis: Set Bend Axis Deadband Clear Drive Faults On InputTimer= tim0:250 Clear Drive Faults Off The file is found in c:\cnc\config\cncprocesslist |
Other Pages
- Back to CNC Bender Tutorials
- Back to CNC Bender
