Difference between revisions of "CNC Bender v12.1.1"
From ATTWiki
(Created page with "<table> <tr> <td width=200> ==v12.1 - August 14, 2013== *Back to CNC Bender Software Updates </td> <td width=300> 300px<br> <...") |
(→25px FIX: FRB Clear Part Fixed) |
||
| Line 20: | Line 20: | ||
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
| − | <td width= | + | <td width=500> |
CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder. | CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder. | ||
</td> | </td> | ||
Revision as of 15:48, 14 August 2013
v12.1 - August 14, 2013
|
|
See CNC Bender Customer Service Page for an update.
FIX: FRB Clear Part Fixed
|
CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder. |
NEW: "Store Jog Commands When In Cycle Hold" Option
|
A new low-level option is added that changes the behavior of motion-controlled Jog commands when the control is in Cycle Hold. The "Store Jog Commands When In Cycle Hold" command will allow the bender to store and act on any jog command that was pressed immediately after entering CYCLE START. |
Other Changes
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
