Difference between revisions of "CNC Bender v12.1.1"
From ATTWiki
(→25px NEW: "Store Jog Commands When In Cycle Hold" Option) |
(→25px NEW: Processor Now Checks to See if Inputs are Internal) |
||
| Line 32: | Line 32: | ||
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
| − | <td width= | + | <td width=500> |
CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.<br><br> | CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.<br><br> | ||
</td> | </td> | ||
Revision as of 15:51, 14 August 2013
v12.1 - August 14, 2013
|
|
See CNC Bender Customer Service Page for an update.
FIX: FRB Clear Part Fixed
|
CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder. |
NEW: Processor Now Checks to See if Inputs are Internal
|
CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O. |
Other Changes
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
