Difference between revisions of "CNC Bender v12.8"

v12.8 - February 1, 2014

• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.

Note: This fix applies only to bender with non-standard axis numbering for the Feed or Rotate axes (that does not match Feed = 1, Rotate = 2)</h> Custom commands can be entered after every bend in the FRB page. SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move.

• For example, the ROTATE was programmed at 90 degrees. The custom move is 89 degrees - so the finish up command should be set to 1 degree to come to the full 90. However, the finish-up command was 90 degrees - which caused the rotate to move to 89 + 90 = 179 degrees.
  
  
• This problem occurred on benders where the ROTATE axis is set to a non-standard machine axis 3 because the machine axis number was hard coded into the process list builder.
  
  
• Process list builder now has logic that anticipates that the machine axis number for any motion actuator can change depending on the application.

</td>

</td> </tr> </table>

ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)

Other Changes

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands