Difference between revisions of "VTube Intersection Point Tolerances"

XYZ Intersection Tolerances

• Back to VTube-LASER

The XYZ intersection tolerances allow you to quickly qualify a part using +/- tolerances to the intersection points.

The intersection tolerances are based on values are that follow the three axes in a coordinate system. Since the tolerances measure along the axes, as of version 1.93, these tolerances can be positive or negative to also indicate a direction.

The XYZ intersection tolerances are based on the XYZ deviations as shown in the model in this screen image.

In this case, most of the error is in the Y axis. It can be verified by seeing that the intersection point of the derived data is visually above the master point. (You can click on the image to make it larger.) The deviation data indicates that it is exactly 0.012" above the master point in the Y axis.

The reason the grid is entirely green is because the tolerance values are higher than the deviation values (in this case the tolerances are 0.039").

Note: The 0.013" value is the 3D deviation from point to point. Unless it lays on an X, Y, or Z axis, it is usually slightly larger than any of the other values.

You can set these tolerances in two places in VTube-LASER. The first place is in the Inspection Data menu.

Click on the Change Grid Setup button until you see the tolerances in the grid like we show in the image on the right.

Then select and change any tolerance value. The grid will allow you to edit only the tolerances.

The second place to edit the value is in the VTube-LASER Expanded Window.

Click on the Expanded Window button to display the Expanded Window, and then make changes to the tolerances there. (You can click on the image to see it larger.)

The benefit of the Expanded Window is that you can view all the tolerances at the same time.

The intersection deviation grids allow you to set the default tolerance to every value in a row, column, or even the entire grid using a popup menu

To use this feature, single click on a tolerance value, the right click and choose the action.

The screen images on the right show an example of before and after changes made to an entire column:

The XYZ Intersection deviation values can be included in reports:

1. plus tolerance values
   
2. minus tolerance values
   
3. out of tolerance values