Difference between revisions of "Setup VTube for Supravision Network Communication"

Revision as of 03:36, 9 January 2015

VTube-STEP Setup for Supravision Network

Use the VTube-STEP Bender Output menu to setup and send new part data to a bender using Supravision Network protocol:

Go to the SV Network tab and choose the bender number and set the shared path where Supravision Network communications occurs.

• The Supravision Network protocol uses a bender number (from 1 to 99) to indicate which bender should pickup and use the Supravision file that is being saved by VTube-STEP to the file path in the network box.
  
  

Setup SolidWorks with Default Templates

The solution is to setup the Default TEMPLATE path in Tools / Options following these steps.

Step 1: Move the mouse over the menu arrow to the right of the SolidWorks logo in the upper right corner.

Step 2: Move the mouse to Tools and down to Options - Click on Options

Step 3: Click on Default Templates in the left column

Step 4: Choose the template files

Click on the ellipses buttons to setup the default path in these boxes. SolidWorks will suggest a file that already exists on the disk. Click on that file.

Fill in all three boxes with filenames.

Click on OK. SolidWorks is ready to receive VTube commands.

Other Pages

• VTube-LASER
• VTube-STEP
• Benderlink
• Benderlink for SolidWorks