Difference between revisions of "VTube-LASER to Eaton Leonard Premier Communications Tutorial"
From ATTWiki
| Line 3: | Line 3: | ||
<td width=200> | <td width=200> | ||
VTube-LASER uses the legacy Eaton Leonard Current Loop protocol to communicate with Premier controls. The protocol requires that an RS-232 signal be converted to Current Loop, then sent to the bender.<br><br> | VTube-LASER uses the legacy Eaton Leonard Current Loop protocol to communicate with Premier controls. The protocol requires that an RS-232 signal be converted to Current Loop, then sent to the bender.<br><br> | ||
| − | + | This diagram demonstrates how a [[Benderlink Ethernet Module]] completes the Current Loop connection between a [[FARO]] [[VTube-LASER]] computer to an Eaton Leonard [[Premier]], EL-2000, or VELOG bender control. | |
<br><br> | <br><br> | ||
Revision as of 21:52, 23 December 2015
|
VTube-LASER uses the legacy Eaton Leonard Current Loop protocol to communicate with Premier controls. The protocol requires that an RS-232 signal be converted to Current Loop, then sent to the bender. (Click on the image for a closeup.)
|
|
Other Pages
- Back to the Benderlink Ethernet Module Page
- Back to VTube-LASER
