Difference between revisions of "CNC Bender v14.9-r9"

Revision as of 17:47, 23 January 2016

Teach mode is significantly enhanced:

The interface was changed to make teach mode much easier to use.
CNC Bender now warns about motion commands that were added but not actually moved during teach mode.
The finish-up rotation calculations now take into account the avoidance route programmed in the Rotation options (short, long, CW, or CCW).
A serious memory issue was resolved. This issue could cause application error dialogs to display.
Steps were taken to make handling Custom Commands in the process list much faster than before. There is significantly less pause time between Custom Command steps in the process.
Combined servo and non-servo motion in one Custom Command used to cause the command to pause the process if the non-servo was added first. This has been fixed. Any combination of motions in any order now works.

Custom Commands can now be loaded into the COMDEF editor to see what Processlist Builder put in them.

@@ Line 19: / Line 19: @@
 Teach mode is significantly enhanced:<br><br>
-* The interface was changed to make teach mode more usable.<br><br>
+* The interface was changed to make teach mode much easier to use.<br><br>
 * CNC Bender now warns about motion commands that were added but not actually moved during teach mode.<br><br>
 * The finish-up rotation calculations now take into account the avoidance route programmed in the Rotation options (short, long, CW, or CCW).<br><br>