Difference between revisions of "PowerCenter Software"
From ATTWiki
| Line 32: | Line 32: | ||
</table> | </table> | ||
| + | |||
| + | |||
| + | |||
| + | See this page for information on the Automatic Shutdown for CNC Bender operator stations: | ||
| + | http://advancedtubular.com/wiki/index.php?title=CNC_Bender_ProControl_10.0.6.2#NEW:_Automatic_Shutdown_for_BENDER_SYSTEM | ||
Revision as of 16:13, 3 April 2007
PowerCenter software administrates shutdown for CNC Bender operator stations that use the Minute Man MN 350 UPS.
Download the setup file here: http://www.advancedtubular.com/cnc/powercenter-1-0-3-win32.zip
Copy the files out of the zipped file to a temporary location, then run the setup to install the PowerCenter software.
|
Setup of MinuteMan PowerCenter Software |
RECOMMENDED SETTINGS FOR POWERCENTER Software
|
See this page for information on the Automatic Shutdown for CNC Bender operator stations: http://advancedtubular.com/wiki/index.php?title=CNC_Bender_ProControl_10.0.6.2#NEW:_Automatic_Shutdown_for_BENDER_SYSTEM
