Difference between revisions of "Reverse the Tube Ends"
From ATTWiki
(→About Supravision Files) |
(→Reset the Reversed Point Labels) |
||
| (4 intermediate revisions by one user not shown) | |||
| Line 43: | Line 43: | ||
<td> | <td> | ||
[[image:vtube-laser_2.5_reverse_point_labels.png|400px]] | [[image:vtube-laser_2.5_reverse_point_labels.png|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | <tr> | ||
| + | </table> | ||
| + | <br> | ||
| + | |||
| + | |||
| + | == Reset the Reversed Point Labels== | ||
| + | |||
| + | <table> | ||
| + | |||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | You can reset the point labels from being reversed with the XYZ reverse feature.<br><br> | ||
| + | Right click on the XYZ grid and the click on '''Reset Point Labels'''.</td> | ||
| + | <td> | ||
| + | [[image:vtube_v2.5_reset_point_ labels.png|400px]] | ||
| + | [[image:vtube_v2.5_effect_of_reset_point_labels.png|400px]]<br><br> | ||
| + | [[image:vtube-laser_v2.5_tubeimage_with_pointlabels.png|400px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Latest revision as of 15:48, 13 April 2016
|
|
|
Reverse the Tube Ends
|
It is often necessary to reverse the tube ends in order to bend the part from the other end of the tube. To reverse the tube ends, you can right click on the XYZ grids for the MASTER or MEASURED data and click on Reverse XYZ Data. |
|
Reversed Point Labels
|
When you reverse the XYZ rows, VTube will also reverse the point labels. |
|
Reset the Reversed Point Labels
|
You can reset the point labels from being reversed with the XYZ reverse feature. |
|
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
